Problem 11 - Bernoulli's Energy Theorem

Problem 11
A horizontal pipe carries 30 cfs of water. At A the diameter is 18 in. and the pressure is 10 psi. At B the diameter is 36 in. and the pressure is 10.9 psi. Determine the head lost between the two points.
 

Problem 12 - Bernoulli's Energy Theorem

Problem 12
In Figure 4-04, a 50 mm pipeline leads downhill from a reservoir and discharges into air. If the loss of head between A and B is 44.2 m, compute the discharge.
 

fig_4-04_reservoir-to-pipe.gif

 

Problem 13 - Bernoulli's Energy Theorem

Problem 13
The 150-mm pipe line shown in Figure 4-05 conducts water from the reservoir and discharge at a lower elevation through a nozzle which has a discharge diameter of 50 mm. The water surface in the reservoir 1 is at elevation 30 m, the pipe intake 2 and 3 at elevation 25 m and the nozzle 4 and 5 at elevation 0. The head losses are: from 1 to 2, 0; from 2 to 3, 0.6 m; from 3 to 4, 9 m; from 4 to 5, 3 m. Compute the discharge and make a table showing elevation head, pressure head, and total head at each of the five points.
 

fig_4-05_pipe-discharging-from-reservoir.gif

 

Problem 14 - Bernoulli's Energy Theorem

Problem 14
Water discharges through an orifice in the side of a large tank shown in Figure 4-06. The orifice is circular in cross section and 50 mm in diameter. The jet is the same diameter as the orifice. The liquid is water, and the surface elevation is maintained at a height h of 3.8 m above the center of the jet. Compute the discharge: (a) neglecting loss of head; (b) considering the loss of head to be 10 percent of h.
 

fig_4-06_discharge-through-orifice.gif

 

Problem 15 - Bernoulli's Energy Theorem

Problem 15
A pump (Figure 4-07) takes water from a 200-mm suction pipe and delivers it to a 150-mm discharge pipe in which the velocity is 2.5 m/s. At A in the suction pipe, the pressure is -40 kPa. At B in the discharge pipe, which is 2.5 m above A, the pressure is 410 kPa. What horsepower would have to be applied by the pump if there were no frictional losses?
 

fig_4-07-flow-with-pump-zero-headloss.gif

 

Problem 16 - Bernoulli's Energy Theorem

Problem 16
A pump (Figure 4-07) takes water from a 200-mm suction pipe and delivers it to a 150-mm discharge pipe in which the velocity is 3.6 m/s. The pressure is -35 kPa at A in the suction pipe. The 150-mm pipe discharges horizontally into air at C. To what height h above B can the water be raised if B is 1.8 m above A and 20 hp is delivered to the pump? Assume that the pump operates at 70 percent efficiency and that the frictional loss in the pipe between A and C is 3 m.
 

fig_4-07_flow-with-pump.gif

 

Problem 17 - Bernoulli's Energy Theorem

Problem 17
In Figure 4-08 is shown a siphon discharging water from reservoir A into the air at B. Distance 'a' is 1.8 m, 'b' is 6 m, and the diameter is 150 mm throughout. If there is a frictional loss of 1.5 m between A and the summit, and 1.5 m between the summit and B, what is the absolute pressure at the summit in kiloPascal? Also determine the rate of discharge in cubic meter per second and in gallons per minute.
 

fig_4-08_siphon-tube.gif

 

Problem 18 - Bernoulli's Energy Theorem

Problem 18
Figure 4-09 shows a siphon discharging oil (sp gr 0.90). The siphon is composed of 3-in. pipe from A to B followed by 4-in. pipe from B to the open discharge at C. The head losses are from 1 to 2, 1.1 ft; from 2 to 3, 0.7 ft; from 3 to 4, 2.5 ft. Compute the discharge, and make table of heads at point 1, 2, 3, and 4.
 

fig_4-09_siphon-pipe.gif

 

Problem 19 - Bernoulli's Energy Theorem

Problem 19
A pump draws water from reservoir A and lifts it to reservoir B as shown in Figure 4-10. The loss of head from A to 1 is 3 times the velocity head in the 150-mm pipe and the loss of head from 2 to B is 20 times the velocity head in the 100-mm pipe. Compute the horsepower output of the pump and the pressure heads at 1 and 2 when the discharge is: (a) 12 L/s; (b) 36 L/s.
 

fig_4-10_flow-with-pump.gif

 

Problem 20 - Bernoulli's Energy Theorem

Problem 20
The 600-mm pipe shown in Figure 4-11 conducts water from reservoir A to a pressure turbine, which discharges through another 600-mm pipe into tailrace B. The loss of head from A to 1 is 5 times the velocity head in the pipe and the loss of head from 2 to B is 0.2 times the velocity head in the pipe. If the discharge is 700 L/s, what power is being given up by the water to the turbine and what are the pressure heads at 1 and 2?
 

fig_4-11_flow-with-turbine.gif

 

Pages

Subscribe to CE Reference RSS